LBL Lighting Veneto Venti SP - Manual (Page 4)

4
HUB CABLE
CLUTCH
AIRCRAFT
CABLE
GLASS
Feed the aircraft cables through the cable clutches in
the hub.
Pull the aircraft cable up behind the hub to raise the
glass. Make sure that the glass is at least 3.5” away
from the lamp, but high enough to cover the lamp.
To lower the glass shade, push the cable clutch in and
pull the aircraft cable down.
When the glass is in the desired position, trim the excess
aircraft cable behind the hub.
NOTE:
To replace the lamps, simply reach the lamp
from top of the glass shade. The canopy is equipped
with a max 45 tilt capability which may assist in
°
lamp replacement.
DO NOT REMOVE THE GLASS.
NOTE:
Make sure to support the glass shade while
adjusting the aircraft cables. An assistant is
recommended to complete these steps.
5C
7
8
9
10
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company