Adjust the fixture height (optional), Install the fixture, 3a 2a – LBL Lighting Veneto Venti SP User Manual

Page 2

Temporarily remove the canopy and half ball pivot from the

assembly by unscrewing the pivot from the hub and pulling the

fixture wires through.

Feed the fixture wires through the optional extension stem(s)

and tighten completely to the threaded nipple on the hub.

Feed the fixture wires through the canopy and half ball pivot

and tighten completely to the threaded nipple on the new

extension stem.

Adjust the Fixture Height (Optional)

EXTENSION STEM

THREADED NIPPLE

HUB

HALF BALL PIVOT

CANOPY

NOTE:

Use a 24" stem for the minimum 34" overall

height.To extend the fixture height to 46", or 58", or 70",
use the additional 12", or 24", or combination of 12" and
24" provided extension stems respectively.The extension
stems are not field cuttable.

Place all wire and wire nut connections inside the
electrical box.

Align the canopy holes with the crossbar holes. Secure
the canopy in place by tightening the four screws with
the provided Allen wrench.

SCREW

ALLEN

WRENCH

Connect the fixture to a suitable ground in accordance
with local electrical codes.

Connect the black fixture wire to the hot power line wire
with a wire nut.

Connect the white fixture wire to the neutral power line
wire with a wire nut.

Install the Fixture