LBL Lighting Chicago Jazz SCF - Manual (Page 4)

4
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2012 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
Lift the socket assembly out of the fixture.
Remove the old lamp.
Push the new lamp base into the socket.
Insert the socket assembly back into the fixture.
SOCKET
Use GX24Q-3 Base
Triple Tube Compact Fluorescent Lamp.
MAX 32 Watt
LAMP
6A
1
2
Replacing the Lamp
3
4
Place all wires, wire nut connections, ballast, and the
secondary strain relief properly inside the canopy.
Loosen the set screw on the primary strain relief.
Align the canopy center hole with the crossbar center
hole.
Slide the canopy up against the ceiling and secure it in
place by tightening the primary strain relief into the
crossbar.
Push the cord into the canopy and line up the marked
point on the cord with bottom of the primary strain
relief.
Tighten the plastic set screw to secure the cord.
Do not turn the cord.
STRAIN RELIEF
NOTE: It is recommended that one person hold the
fixture while the electrician finishes the installation.
CORD
SET SCREW
4D
13
14
15
16
17
18
1 Adjust the aircraft cables until the fixture is level; feed
the cable into the cable clutch to raise the fixture and
push in on the cable clutch nipple to release the cable
and lower the fixture.
CABLE
CLUTCH CABLE
CLUTCH
1
5A
Adjust the Suspension Cables
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.