LBL Lighting Chicago Jazz S - Manual (Page 2)

FIXTURE WIRE
WITH WHITE
STRIP FIXTURE WIRE
WITHOUT WHITE
STRIP
Install the fixture
NOTE:
Make sure to support the fixture while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
Feed the aircraft cables through the cable clutch in the
canopy.
Evenly pull the aircraft cable up through the canopy to
raise the fixture to the desired length.
Cut off the excess aircraft cable leaving enough for fine
leveling later.
2 1
2 2
2 3
NOTE:
The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
If necessary loosen the set screw and feed the power
cord through the canopy.
Once the desired length and look is determined, tighten
the set screw on the strain relief.
Leave 6 inches of cord behind the canopy and cut off
the extra cord.
2 5
3A
CABLE
CLUTCH
AIRCRAFT
CABLE
CANOPY
3
1
6
2 6
Note: Taping down the frayed end of the cloth cord
may assist in feeding it through the strain relief.
2
Install the Canopy
4A
3B
STRAIN RELIEF POWER CORD
SET
SCREW
2 4
3C
Strip the cable behind the canopy, and strip the ends of
the inner wires. 2 7
FIXTURE WIRE
WITH GREEN
STRIP
Connect the mounting plate bare wire and the fixture
wire with the green strip to a suitable ground in
accordance with local electrical codes.
Connect the wire with the white strip to the neutral
power line wire with a wire nut.
Connect the remaining wire to the hot power line wire
with a wire nut.
5
2 1
2 2
2 3
3
1 2
1