Mount the fixture – LBL Lighting Constellation Grande SCF User Manual
Page 4
4
3B
10
2
5
2
6
2
7
2F
4"
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife.
.
Make sure not to nick the inner wires
Strip the end of the wires.
7
11
7
7
3A
10
2
1
2
2
Feed the fixture wires through the crossbar center hole
and then pull them out of the electrical box.
Install the secondary strain relief by first feeding the
power cord through it.
Snap the strain relief tab into place.
Pull the cord to take up the slack and fit the rest of the
cord in the strain relief’s openings.
2
3
2
4
1
2
3
4
4
TAB
BALLAST
Connect the red ballast wires to one of the insulated
pendant wires.
Connect the yellow ballast wire to the other insulated
pendant wire.
Ground the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white ballast wire to the neutral power line
wire.
Connect the black ballast wire to the hot power line
wire.
2
8
2
9
CAUTION:
Make sure to support the fixture while
installing, an assistant will be needed to complete
the remaining steps.
Mount the Fixture
12
13
9
8
7
6
5
7