beautypg.com

Siemens LI48932 User Manual

Page 13

background image

13

Operating the extractor hood

The most effective method of removing

vapours produced during cooking is to:

❑ Switch the ventilator ON

as soon as you begin cooking.

❑ Switch the ventilator OFF

a few minutes after you have finished
cooking.

Switching on appliance:

Press the

L

or

+

button.

❑ The fan starts at Setting

}

.

1. To increase the fan settings or switch on

the intensive setting

ç

, press the

+

button.

❑ The intensive setting operates at

maximum power which should be
used only briefly.
If the intensive setting is not switched
off manually, the fan automatically
switches back to Setting

}

after

10 minutes.

2. To switch off the intensive setting

ç

or

switch back to fan settings

~

}

|

and

switch off the extractor hood
completely, press the

button.

Switching on the fan settings/intensive
setting:

Intermittent

ventilation

Light
on / off

Display:
❑ Fan settings / Intensive

setting

ç

Saturation – grease filter

#

Saturation –
activated carbon filter

ã

Fan
on / off

Fan – off –
Fan settings
– lower –

Fan – on –
Fan settings
– higher –

Intermittent ventilation

❑ Used for ventilating the kitchen at hourly

intervals at the lowest fan setting, round
the clock.

Switching on appliance:

Press the button and insert the filter
drawer.

❑ The fan runs for 5 minutes at Setting

|

,

then switches off for 55 minutes. This
process is repeated every hour.

Switching off:

Press the button.

Switching off:

There are 2 different ways of switching off
the appliance.

Switching off directly:

Press the

L

button.

Important: All fan functions are switched
off.

Switching off appliance with fan run-on:

Insert filter drawer all the way. The fans
operate in the last switched-on stage for
around another 10 minutes and then switch
off.

❑ When the extractor hood is switched off,

the operating mode and the fan setting
are saved. When the filter drawer is
pulled out, the extractor hood switches
on again at the saved settings.

❑ If the intensive setting is switched on

when the filter drawer is inserted, the
intensive setting automatically switches
back during run-on.

❑ If intermittent ventilation is switched on, it

continues operating normally following
run-on.

Light

❑ The light can be used at any time, even

when the appliance has been switched
off.

Switching on/off: Press the

a

button.

Adjusting the brightness:

❑ Hold down the

a

button until the

desired brightness is obtained.

Grease filters:

Metal-mesh filters are used to trap the
grease particles in the cooking vapours.

The filter mats are made from non-
combustible metal.

Caution:

As the filter becomes more and more satu-
rated with grease, there is an increased risk
of fire and the function of the extractor
hood may be impaired.

Important:

By cleaning the metal grease filters at
appropriate intervals, the possibility of them
catching fire as a result of a build-up of heat
such as occurs when deep-fat frying or
roasting is taking place, is reduced.

Saturation indicator:

When the grease filters reach saturation
point, an acoustic signal is sounded for 6
seconds after the fan has switched off, and
an

#

appears in the display. The grease

filters should be cleaned straight away.

Cleaning the metal-mesh grease filters:

❑ The filters can be cleaned in a

dishwasher. However, they may become
slightly discoloured.

Important:
Do not wash highly saturated metal-
mesh grease filters with other utensils.

❑ If cleaning the filters by hand, soak them in

a hot soap solution. Then brush the filters,
rinse thoroughly and leave to drain.

Clean the support frame for the grease

filters by hand.

Filters and maintenance