Siemens EG20158EU - Manual (Page 11)

11
Your new appliance
Page 2 shows an overall view of your new appliance as well as
the burner power.
Accessories
The following accessories can be purchased from the
Technical Assistance Service:
--------
Code
The manufacturer accepts no liability if these accessories are
not used or are used incorrectly.
Possible combinations
Gas burners
There are indications to show which burner each control knob
operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Do not swap the burner caps around.
Switching on a burner
Turn the desired burner control knob anticlockwise to the
required position.
If the burner does not switch on, wait at least a minute until
trying again.
Safety system
All the hotplates have a security device (thermocouple).
If the burner is switched off during operation (e.g. due to a
draught), the appliance automatically switches on the hotplate
again.
If relighting is not successful (for example, due to food remains
on the burner), the gas supply to this burner is turned off and a
warning sound is given. Turn the control knob to 0.
Switching off a burner
Turn the corresponding control knob clockwise to the 0 setting.
Automatic off
After six hours of operation, the appliance switches off
automatically. Turn all control knobs to setting 0; the appliance
can now be switched on again.
Power levels
The progressive control knobs can be used to control the
power needed, from minimum to maximum power.
Protection against overheating
The hob has a protection against overheating system to protect
the electrical installation. This will turn of all burners in case of
overheating and will emit a warning sound.
Turn all control knobs to setting 0. Wait until the appliance has
cooled down sufficiently and turns off. Now you can reconnect
the appliance normally.
Warnings
This appliance will not function if it is not connected to the
mains or if the electricity supply is cut off.
It is normal to hear a soft whistling noise while the burner is
operating.
When first used, it is normal for the burner to give off odours.
This does not pose any risk and does not indicate a
malfunction. They will disappear in time.
An orange-coloured flame is normal. This is caused by the
presence of dust in the atmosphere, spilt liquids, etc.
Simmer Plate
This accessory has been
designed to reduce the level
of heat at the lowest power
setting.
Place the accessory directly
on the pan support with the
cones facing upwards, never
directly over the burner. Cen-
tre the pan over the acces-
sory.
HZ298105 Simmer Plate
Hob Oven
EG20158EU
EG20358NL HV33AB520
HV23AB510
LJQLWLRQ VSDUNHU WKHUPRFRXSOH
Setting
Ú
Control knob off
High flame
™
Maximum capacity or aperture and elec-
tricity on
Low flame
š
Minimum capacity or aperture