Descale required, Start descaling, Empty drip tray insert drip tray – Siemens TE509501DE User Manual
Page 37: Fill descaler press start, Place container press start, Descale in progress, Clean / fill water tank press start
37
de
en
Never interrupt the service programme!
Do not drink the liquids!
Never use vinegar, vinegarbased products,
citric acid or citric acidbased products!
Never put descaling tablets or other descal
ing agents in the ground coffee drawer or
the drawer for cleaning tablets (4)!
Specially developed descaling and
cleaning tablets are available from
retailers or customer service.
Order number
Retail
Customer
service
Cleaning
tablets
TZ60001
310575
Descaling
tablets
TZ60002
310967
Descaling
Duration: approx. 25 minutes.
Important: If there is a filter in the water
tank (17), it needs to be removed before the
descaling programme is run.
If the message
Descale required!
ap
pears on the display, press the
e
off /
j
button (13) for 3 seconds and then press
the
start button (10). The descaling pro
gramme will start. To descale the appliance
before being prompted, press the
e
off /
j
button (13) for at least 3 seconds. Then
press the
e
off /
j
button (13) briefly twice.
Turn the upper rotary knob (15) until
Start
descaling
appears in the display. To start
the descaling procedure, press the
start
button (10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
N.B.: If the water filter is activated, the
display will prompt you to remove the filter
and then press the
start button (10) again.
Remove the filter now if you have not al
ready done so. Press the
start button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty wa
ter tank (17) up to the
0,5l mark and dis
solve 2 Siemens descaling tablets in it.
● Press the
start button (10).
Place container
Press start
● Place a receptacle with a capacity of at
least 0.5 litres under the outlet (6a).
● Press the
start button (10).
Descale in progress
The descaling pro gramme will now run for
about 20 minutes.
Clean / Fill water tank
Press start
● Rinse the water tank (17) and refill it with
fresh water up to the
max mark.
● Press the
start button (10).
Descale in progress
The descaling pro gramme now runs for
about 3 minutes and rinses the appliance.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the filter if one is being used. The
appliance has completed descaling and is
ready for use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.
TE506_1DE.indb 37
20.06.2012 11:58:03