Siemens TE509501DE - Manual (Page 33)

33
de en
4. Select the required drink by turning the
upper rotary knob (15) (only one cup
possible).
5. Press the start button (10).
Coffee is brewed and then poured into the
cup.
N.B.: Repeat the procedure for another
cup of coffee. If no coffee is taken within
90 seconds, the brewing chamber empties
automatically to avoid overfi lling. The appli­
ance rinses.
Dispensing hot water
¡ Risk of burns!
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
The appliance must be ready for use.
1. Place the pre­warmed cup or glass
under the outlet of the milk frother (6).
2. Set the rotary selector (6b) to the
horizontal position.
3. Press and hold the h / g button (12)
for approx. 3 seconds. The appliance
heats up. Hot water runs out of the milk
frother outlet (6) for about 40 seconds.
4. Press the h / g button (12) again to
cut the process short.
Preparing milk froth and
warm milk
¡ Risk of burns!
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
Tip: You can foam the milk fi rst and then
dispense coffee, or foam the milk separately
and pour it onto the coffee.
The appliance must be ready for use.
1. Place a pre­warmed cup under outlet
(6a).
2. Insert the milk tube (6c) into a milk
container.
3. Turn the rotary selector (6b) to “Milk
froth”
j
or “Warm milk”
i
.
4. Press the h / g button (12).
The h / g button (12) fl ashes and
the appliance now heats up for approx.
20 seconds.
¡
Risk of burns!
Milk froth or warm milk comes out of the
milk frother (6) at high pressure. Splashes
of milk can scald. Do not touch the outlet
(6a) or aim it at anyone.
5. End the process by pressing the
h / g button (12).
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
TE506_1DE.indb 33 20.06.2012 11:57:58