Siemens TE509501DE - Manual (Page 30)

30
de en
Water fi lter
A water fi lter can prevent scale buildup.
Before a new water fi lter is used, it must be
rinsed. To do this, proceed as follows:
1. Press the water fi lter fi rmly into the wa­
ter tank with the aid of the measuring
spoon (19).
2. Fill the water tank (17) with water up to
the max mark.
3. Press and hold the
e
off / j button (13)
for at least three seconds. The menu
opens.
4. Press the
e
off / j button (13)
repeatedly until the display shows
No / Old filter .
5. Select Activate filter with the upper
rotary knob (15).
6. Press the start button (10).
7. Place a receptacle with a capacity of
0.5 litres under the outlet (6a).
8. Press the start button (10).
9. Water will now fl ow through the fi lter to
rinse it.
10. Empty the container.
The appliance is ready to use once more.
Note: Rinsing the fi lter simultaneously ac­
tivates the setting for the Change filter!
display.
The fi lter is no longer effective when the
Change filter! display appears, or at
the latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no build­up of limescale (this could
damage the appliance). Replacement fi lters
can be obtained from retailers (TZ70003) or
from customer service (467873). If no new
fi lter is used, turn the filter setting to
No / Old .
Note: You can use the fi lter indicator to
mark the month in which you inserted the
fi lter. You can also mark the month in which
you will need to replace the fi lter next (at
the latest after two months).
Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
fi lter should be rinsed before the appliance
is used again. To do so, dispense a cup of
hot water and pour it away.
Menu settings
You can adapt the appliance to your indi­
vidual needs in the menu settings.
1. Hold the
e
off / j button (13) down for
at least 3 seconds.
2. Press the
e
off / j button (13) repeated­
ly until the required menu item appears
in the display.
3. Select the required setting with the
upper rotary knob (15).
4. Confi rm by pressing the start button (10).
To leave the menu without making any
changes, turn the rotary selector to Exit
and press the start button (10).
TE506_1DE.indb 30 20.06.2012 11:57:58