Chapter 3. ap mode configuration, 1 external network connection, 1 network requirement – Airlink101 APO1010 User Manual
Page 23
18
Chapter 3. AP Mode Configuration
When AP mode is chosen, the system can be configured as an Access Point. This section provides detailed explanation for
users to configure in the AP mode with help of illustrations. In the AP mode, functions listed in the table below are also
available from the Web-based GUI interface.
Option System
Wireless
Utilities
Status
Operating Mode
General Settings
Profiles Settings
System Overview
LAN
Advanced Settings
Firmware Upgrade
Clients
Management
Virtual AP
Network Utility
WDS List
Time Server
WDS Setup
Reboot
Extra Info
SNMP
Event
Log
Functions
UPNP
Table 3-1: AP Mode Functions
3.1 External Network Connection
3.1.1 Network Requirement
Normally, APO1000/APO1010 connects to a wired LAN and provides a wireless connection point to associate with wireless
client as shown in Figure 3-1. Then, Wireless clients could access to LAN or Internet by associating themselves with
APO1000/APO1010 set in AP mode.
Figure 3-1 Access Point on a Wired LAN Configuration
APO1000/APO1010