Airlink101 APO1010 - Manual (Page 14)

9
1.5 Specification
„ Wireless Architecture Mode
Î AP Mode
9 Pure AP Mode
• It can be deployed as a tradition fixed wireless Access Point
• It allow wireless clients or Stations(STA ) to access
9 AP/WDS Mode
• This enables the wireless interconnection of Access Point in an IEEE802.11 network .and accept wireless
clients at the same time
Î WDS Mode
9 This enables the wireless interconnection of Access Point in an IEEE802.11 network.
9 It allows a wireless network to be expanded using multiple access point without the need for a wired backbone
to link them.
9 This also be referred to as repeater mode.
9 It can’t allow wireless clients or Stations (STA) to associate.
Î CPE Mode
9 WiFi connection as WAN , in CPE mode , the device run as DHCP server to assign IP address to clients out of a
private IP address pool behind a NAT
Î Client Bridge + Universal RepeaterMode
9 A wireless repeater and bridge with DHCP server enabled, clients on the same subnet as host AP(Primary
Router).
6. Networking
Î Support Static IP, Dynamic IP(DHCP Client) and PPPoE on WiFi WAN Connection
Î Support PPTP/L2TP/IP Sec Pass Through
Î PPPoE Reconnect – Always On , On demand, Manual
Î MAC Cloning
Î DHCP Server
Î 802.3 Bridging
Î Masquerading (NAT)
Î Proxy DNS
Î Dynamic DNS
Î NTP Client
Î Virtual DMZ
Î Virtual Server (IP / Port Forwarding)