Wagner ProCoat Plus - Manual (Page 16)

Follow these steps if you used latex materials anD if
you have a garden hose available.
If you do not have a garden hose available, follow the
Cleanup - Oil-Based materials instructions on page 18.
English 16
Cleanup
Start You will need:
• A water source that can be delivered
with a garden hose (latex materials only)
• Mineral spirits if using oil-based material
• Empty waste container
• A container with warm, soapy water
• When using latex material, clean sprayer and components with warm, soapy water. For oil based
material use mineral spirits. Never use mineral spirits with latex materials
• NEVER use gasoline to clean sprayer
• Dispose of used cleaning solution properly
• Thorough cleaning and lubrication of sprayer is important to ensure proper operation after storage
• If you flush your sprayer with mineral spirits, repeat Cleanup instructions using warm, soapy water.
Follow these steps whenever cleaning with mineral spirits:
• If spraying or cleaning with oil-based materials, the spray gun must be grounded while preparing
the spray hose or cleaning.
• Ground the gun by holding it against the edge of a metal container while purging. Failure to do so
may lead to a static electric discharge which may cause a fire.
• Always flush spray gun at least one hose length from spray pump.
• If collecting flushed solvent in one gallon metal container, place it into an empty five gallon
container, then flush.
• Area must be free from vapors.
• Follow all cleanup instructions.
Cleaning notes - read before cleaning
1. Perform Pressure Relief Procedure
(page 7).
2. Remove the spray tip and
place into container filled
with warm, soapy water.
3. Place the suction tube and return tube
into an empty waste container.
4. Using a garden hose, rinse off the
suction tube, return tube and inlet filter.
Empty the waste container of all fluids.
2
PRIME
1 3 4
MINERAL
SPIRITS
or
STOP