Spraying troubleshooting, Clear the spray tip, 12 clear the spray tip – Wagner ProCoat Plus User Manual

Page 12: Follow any or all the procedures listed on, Clear the spray tip start you will need

English

Spraying

Troubleshooting -

Clear the

Spray Tip

Start

You will need:

• Scrap material / cardboard

Do not attempt to unclog or

clean the tip with your finger.

High pressure fluid can cause

injection injury.

1. Lock the spray gun.

2. Rotate reversible spray tip 180 degrees

to ClEan position (arrow pointing

toward the rear of the spray gun).

note: If spray tip is difficult

to rotate, relieve pressure

by 1) slowly turn PRIME/

SPRAY knob to PRIME, 2)

unlock the spray gun and

3) squeeze trigger while

pointing at scrap material/

cardboard. Release

trigger, lock the spray gun,

and try rotating spray tip

again.

3. Make sure the PRIME/SPRAY

knob is turned to SPRAY -

MINIMUM PRESSURE.

Unlock the spray gun.

4. Point at a piece of scrap material / card-

board and squeeze trigger until material

comes out in a high pressure stream.

Release the trigger and lock the spray

gun.

5. Reverse the spray tip so

the arrow points forward.

Unlock the spray gun and

resume spraying.