Clean the inlet filter, 14 clean the inlet filter, Spraying troubleshooting – Wagner ProCoat Plus User Manual
Page 14: Clean the inlet filter start you will need
English
14
Spraying
Troubleshooting -
Clean the
Inlet Filter
Start
You will need:
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
ImPORTanT: make sure your floors and
furnishings are covered with drop cloths
to prevent accidental drips.
1. Unscrew the inlet filter from the fitting
on the end of the suction tube.
3. Replace the cleaned filter by
threading it back into the fitting on the
end of the suction tube.
2. Clean the filter using the appropriate
cleaning solution (warm, soapy
water for latex materials, mineral
spirits for oil-based materials).
note: If after completing all of the steps
in Spraying Troubleshooting you are still
experiencing problems spraying, refer to
the Troubleshooting section (page 22).
1
3
2