Clean the spray gun filter, 13 clean the spray gun filter, Spraying troubleshooting – Wagner ProCoat 9185G User Manual

Page 13: Clean the spray gun filter start you will need

English

Spraying

Troubleshooting -

Clean the Spray

Gun Filter

Start

You will need:

• Wrench

• Warm, soapy water for latex material

• Mineral spirits for oil based materials

• Replacement spray gun filter (if necessary)
ImPORTANT: Never clean the filter by

poking it with a sharp object.

1. Peform the Pressure

5. Inspect the filter for

damage. Replace if any

holes or tears are found.

4. Remove the filter from the

housing. Clean with appropriate

cleaning solution (warm, soapy

water for latex materials; mineral

spirits for oil-based materials).

2. Pull trigger guard

from filter housing.

6. Replace cleaned filter, tapered

end first, into the gun housing.

Note: It is important to place

tapered end first to ensure proper

sprayer operation.

3. Tighten the wrench over the

wrench flats (a). Unscrew the

filter housing using a wrench.

Note: You DO NOT need to

remove the spray hose from the gun

to clean the filter.

7. Reassemble the spray gun.

SPRAY

(a)