Spraying troubleshooting, Clear the spray tip, 12 clear the spray tip – Wagner ProCoat 9185G User Manual

Page 12: Clear the spray tip start you will need

English

Spraying

Troubleshooting -

Clear the

Spray Tip

Start

You will need:

• Scrap material / cardboard

Do not attempt to unclog or

clean the tip with your finger.

High pressure fluid can cause

injection injury.

1. Lock the spray gun.

2. Rotate spray tip 180 degrees from its

current position.

Note: If spray tip is difficult

to rotate, relieve pressure

by 1) slowly turn PRIME/

SPRAY knob to PRIME, 2)

unlock the spray gun and

3) squeeze trigger while

pointing at scrap material/

cardboard. Release

trigger, lock the spray gun,

and try rotating spray tip

again.

3. Make sure the PRIME/

SPRAY knob is turned to

SPRAY.

Unlock the spray gun.

4. Point at a piece of scrap material /

cardboard and squeeze trigger until

material comes out in a high pressure

stream. Release the trigger and lock the

spray gun.

5. Rotate spray tip forward to one

of the SPRAY positions.

Unlock the spray gun and

resume spraying.

SPRAY

NARROW

WIDE