Wagner ProCoat 9195 - Manual (Page 6)

English 6
1. Assembly
Start
1. Insert the ends of the hose
bracket into the holes of the
handle as shown.
2. Remove the plug from inside
the hose fittings and remove the
cap on the outlet valve. Discard
both.
6. Remove cap from the Sureflo
valve (a).
Thread the suction tube onto the
inlet valve and tighten firmly by
hand.
note: Be sure that the threads are
straight so that the fitting turns freely.
5. Thread the other end of the
hose to the spray gun. Hold
the gun with one adjustable
wrench, and tighten the hose
nut with the other.
4. Hold the port with an
adjustable wrench, and
tighten the hose with the
other.
7. Press the return tube onto
the return tube fitting.
Squeeze clip over the return
tube fitting to secure the
return tube.
3. Thread one end of the high
pressure spray hose to the
spray hose port.
You will need:
• Two adjustable wrenches
ImPORTanT: Do not plug in the
power cord until assembly is
complete.
note: It will be much easier to attach the
hose to the sprayer if you uncoil it first.
1 2 3
6 5 4 7
(a)