Wagner ProCoat 9195 - Manual (Page 12)

English 12
Spraying
Troubleshooting -
Clear the
Spray Tip
Start You will need:
• Scrap material / cardboard
Do not attempt to unclog or
clean the tip with your finger.
High pressure fluid can cause
injection injury.
1. Lock the spray gun. 2. Rotate spray tip 180 degrees from its
current position.
note: If spray tip is difficult
to rotate, relieve pressure
by 1) slowly turn PRIME/
SPRAY knob to PRIME, 2)
unlock the spray gun and
3) squeeze trigger while
pointing at scrap material/
cardboard. Release
trigger, lock the spray gun,
and try rotating spray tip
again.
3. Make sure the PRIME/
SPRAY knob is turned to
SPRAY.
Unlock the spray gun.
4. Point at a piece of scrap material /
cardboard and squeeze trigger until
material comes out in a high pressure
stream. Release the trigger and lock the
spray gun.
5. Rotate spray tip forward to one
of the SPRAY positions.
Unlock the spray gun and
resume spraying.
1 2
SPRAY
PR IM E
3 4 5
Or
Or
NARROW
WIDE