Pre card char property, Post card char property, Pre tk char property – MagTek USB KB INTELLIHEAD User Manual
Page 31
Section 4. USB Communications
23
PRE CARD CHAR PROPERTY
Property ID:
0x0B
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0
Description:
This character is sent prior to all other card data. If the value is 0 no character
is sent. If the value is in the range 1 – 127 then the equivalent ASCII
character will be sent.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
POST CARD CHAR PROPERTY
Property ID:
0x0C
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0
Description:
This character is sent after all other card data. If the value is 0 no character is
sent. If the value is in the range 1 – 127 then the equivalent ASCII character
will be sent.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
PRE TK CHAR PROPERTY
Property ID:
0x0D
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0
Description:
This character is sent prior to the data for each track. If the value is 0 no
character is sent. If the value is in the range 1 – 127 then the equivalent
ASCII character will be sent.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.