MagTek IntelliStripe 310™ - Manual (Page 23)

Section 4. Magnetic Stripe Application
17
CLEAR DATA COMMAND
Command ID: 80 (Hex)
Description:
This command is used to clear all magnetic stripe data so that the data can no longer be acquired
from the device. After this command is issued, no magnetic stripe data will be available until a
card is read.
After a card is read, the magnetic stripe data is held in the device until:
1.
Another card read occurs.
2. A Clear Data command is issued.
3. The device is power cycled or reset.
Request Message Data: None
Response Message Data: None
Response Message Result Codes:
Success = 00 (Hex)
The command completed successfully.
Example Request:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 00 01 80 00
Example Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 01 80 00