MagTek EC2000 99875600 - Manual (Page 36)

6 - Operation
ExpressCard 2000| Instant Issuance Card Personalization System | User Installation and Operation Manual
Page 36
To determine the stock level in each of the EC2000’s seven card stock hoppers, look through the hopper
bay windows on the right side of the device (see Figure 6-14).
Figure 6-14 - Checking Card Stock Levels
It is important to load only one type of stock into each of the card stock hoppers, otherwise the device will
process cards that do not match the previews the user sees in the card personalization software.
The EC2000 holds a maximum of 700 CR80-sized cards (100 cards per card stock hopper – see section
6.7 Card Stock). It will automatically feed each card off the bottom of the stack. Card customization
software can also specify that stock for a specific operation should be fed into the manual feed slot (see
section 6.11.9 About the Manual Feed Slot for details).
6.7.2 How to Load / Remove Card Stock
Remove card stock from the EC2000 as follows (see this YouTube video for a demonstration):
1) Stand in front of the EC2000 and open the top access door (see section 6.5 Top Access Door
Security for details).
2) Locate the seven card stock hoppers installed in the EC2000 (see Figure 2-3 on page 11).
3) Navigate to Menu > Maintenance to open the Maintenance Menu page.
4) Press the Remove Hoppers button to move the hopper transport out of the way.
5) Remove the hopper you want to unload (see Figure 6-15):