Videotec PTH900 User Manual
Page 27
Pag. 9 PTH910 / PTH911 3201
Pan & tilt connection to DTMRX1/DTRX3 receiver
WARNING: before the connection, make sure that the output voltage of the receiver corresponds to pan & tilt
voltage (Refer to the identification data of the pan & tilt motor and to DTMRX1/DTRX3 manual).
Where to operate: J1 terminal block in the lower printed circuit of the pan & tilt motor (see drawing), terminal block of
the receiver (see DTMRX1/ DTRX3 manual)
Adjustments: connect the terminal block J1 of the pan & tilt motor to that of the receiver according to the following
table
Connection to the receiver
Terminal block J1 (Pan & Tilt)
COM
Com
DOWN
Down
UP
Up
RIGH
Right
LEFT
Left
AUTO
Auto
Preset connection to DTRX3 receiver (only PTH910P / PTH911P)
The following procedure has to be carried out only for PRESET pan & tilt motors connected to DTRX3.
Where to operate : J4 terminal block in the upper printed circuit of the pan & tilt motor, preset terminal block of DTRX3
(see DTRX3 manual)
Adjustments: connect the J4 terminal block of the pan & tilt motor to the preset terminal block of DTRX3 according to
the following table:
Connection to DTRX3
Meaning
Terminal block J4 (Pan & Tilt)
Vcc
+5 Volt
Vcc
Pan
Horizontal
Pan
Tilt
Vertical
Tilt
Gnd
0 Volt
Gnd