Anritsu MG3641A - Manual (Page 144)

SECTION 6 GPIB
6-38
6.7.3 AM subsystem
:AM[ :DEPTh] or
Function Sets the AM depth.
Parameter = –100 to 100 %
= UP
DOWN
Unit
(UP,DOWN: )
Restriction Modulation source porality can be changed by entering negative AM depth value.
:AM[ :DEPTh]?
Function Reads out the AM depth.
Response AM depth.
Restriction None
:AM:STATe
Function Turns ON or OFF the AM.
Parameter = ON or 1
OFF or 0
Unit
Restriction None
:AM:STATe?
Function Reads out the state of AM.
Response AM = OFF
ON
Restriction None
:AM:SOURce
Function Selects the AM modulation source.
Parameter = INT1
INT2
INT3
EXT1
EXT2
Unit
Restriction None
:AM:SOURce?
Function Reads the AM modulation source.
Response AM modulation source = INT1
INT2
INT3
EXT1
EXT2
Restriction None