Anritsu MG3641A - Manual (Page 82)

SECTION 4 OPERATING INSTRUCTIONS
4.11.2 Registering the trigger program
Register the trigger program as follows:
(1) Press the "Trig" [F5] key on the Main Menu (2) to open
the "Trigger Program" menu.
(2) Press the "Enter" [F3] key. The screen switches to the
Main Manu (1) and the device enters the trigger program
registration state.
Subsequent key operations are registered as the trigger
program (the message "Trigger Program Entry" is
displayed to indicate that a key operation is being regi-
stered.
(3) To terminate registering the trigger program, press the
"Trig" [F5] key on the Main Menu (2) again to open
the "Trigger Program" menu. Registering the trigger
program terminates when the "Trigger Program" menu
is opened.
3
2
1