Anritsu MG3641A - Manual (Page 135)

SECTION 6 GPIB
6-29
:FREQuency:OFFSet?
Function Reads out the frequency offset value.
Response Frequency offset value
Restriction None
:FREQuency:SWEep
Function Executes frequency sweep.
Parameter = RUN
STOP
PAUSE
CONT
Unit
Restriction None
:FREQuency:SWEep:STARt
Function Sets the start frequency for a sweep.
Parameter = 0 Hz to 1040 MHz (MG3641A)
0 Hz to 2080 MHz (MG3642A)
Unit
Restriction None
:FREQuency:SWEep:STARt?
Function Reads out the start frequency for sweep.
Response Start frequency for a sweep
Restriction None
:FREQuency:SWEep:STOP
Function Sets the stop frequency for a sweep.
Parameter = 0 Hz to 1040 MHz (MG3641A)
0 Hz to 2080 MHz (MG3642A)
Unit
Restriction None
:FREQuency:SWEep:STOP?
Function Reads out the stop frequency for a sweep.
Response Stop frequency for a sweep
Restriction None
:FREQuency:SWEep:CENTer
Function Sets the center frequency for a sweep.
Parameter = 0.01 Hz to 1039.99999999 MHz (MG3641A)
0.01 Hz to 2079.99999999 MHz (MG3642A)
Unit
Restriction None
:FREQuency:SWEep:CENTer?
Function Reads out the center frequency for a sweep.
Response Center frequency for a sweep
Restriction None