Anritsu MG3641A - Manual (Page 140)

SECTION 6 GPIB
6-34
:AMPLitude[ :OUT]:RELative
Function Turns ON or OFF the relative level display mode.
Parameter = ON or 1
OFF or 0
Unit
Restriction None
:AMPLitude[ :OUT]:RELative?
Function Reads out the state of relative level display mode.
Response Relative level display mode = OFF
ON
Restriction None
:AMPLitude[ :OUT]:OFFSet
Function Sets the output level offset value.
Parameter = –55 dB to 55 dB
Unit
Restriction Unit is dB, only.
:AMPLitude[ :OUT]:OFFSet?
Function Reads out the output level offset value.
Response Level offset value
Restriction None
:AMPLitude[ :OUT]:ISOLation
Function Turnd ON or OFF the isolation mode.
Parameter = ON or 1
OFF or 0
Unit
Restriction None
:AMPLitude[ :OUT]:ISOLation?
Function Read out the state of isolation mode.
Response Isolation mode = OFF
ON
Restriction None
:AMPLitude[ :OUT]:SWEep
Function Executes output level sweep.
Parameter = RUN
STOP
PAUSE
CONT
Unit
Restriction None
:AMPLitude[ :OUT]:SWEep:STARt
Function Sets the start level for a sweep.
Parameter = –143 dBm to +23 dBm
Unit
Retriction None