Troubleshooting, Amplifi er/speakers, Tuner – Kenwood AS-iP70 User Manual
Page 26: Usb/sd/ipod/iphone, How to reset the unit
![background image](/manuals/412268/26/background.png)
AS-IP70
26
A trouble with the unit does not always mean a failure. In case of a trouble, check the following lists before calling for service.
Amplifi er/Speakers
Symptom
Remedy
Page
Audio is not output.
Connect the cords properly.
•
Increase the volume setting.
•
7
8
Clock is not displayed.
Perform clock setting.
• 10
Tuner
Symptom
Remedy
Page
Radio stations cannot be received.
Connect the antennas.
•
Set the correct radio reception band (receiving mode).
•
Tune the frequency of the desired station.
•
7
18
18
Noise interferes.
Install the antenna at a distance from the road.
•
Turn off the electrical equipment used in proximity of this unit.
•
Use the unit at a distance from a TV set.
•
—
Preset stations cannot be displayed.
Perform Auto Preset of radio stations again.
•
Perform Manual Preset of the radio stations of receivable frequencies.
•
18
19
USB/SD/iPod/iPhone
Symptom
Remedy
Page
Music, photo or video is not output even
after an SD card/USB fl ash memory/iPod/
iPhone is connected.
Connect the SD card/USB fl ash memory/iPod/iPhone properly.
•
Connect the USB cable properly.
•
Confi rm that the USB Mass Storage Class-compatible digital audio player
•
is turned on.
9
9
—
How to Reset the Unit
Symptom
Check Point/Treatment
The unit malfunctions (impossibility of
control, erroneous display, etc.)
This unit may malfunction due to disconnection of a cord while the unit is on or to other
extraneous factors. If this happens, reset the unit with the following steps.
1
Remove the external device such as an SD card, USB device or iPod/iPhone from the unit.
2
Disconnect the AC adapter, wait for some tens of seconds and then connect the AC adapter
again.
Troubleshooting
B60-5824-08.indb 26
10.6.8 9:47:52 AM