Kenwood TH-K2E - Discontinued - Manual (Page 52)

38
R
EVERSE
F
UNCTION
The Reverse function exchanges a separate reception
and transmission frequency. So, while using a repeater,
you can manually check the strength of a signal that you
receive directly from the other station. If the station’s
signal is strong, both stations should move to a simplex
frequency and free up the repeater.
To swap the transmission and reception frequencies:
Press [F], [MENU] to switch the Reverse function ON
(or OFF).
• “R” appears when the function is ON.
Note: You can turn the Reverse function ON when you are operating
in Simplex Mode. However, it does not change the Transmission/
Reception frequency.
A
UTOMATIC
S
IMPLEX
C
HECK
(ASC)
While using a repeater, the ASC function periodically
checks the strength of the signal you are receiving from
the other station. If the station’s signal is strong enough
to allow direct contact without a repeater, the “ ”
indicator starts blinking.