Kenwood KFC-W3000L - Manual (Page 5)

English
5
ENGLISH
Connecting KFC-W3000L and KFC-W3000LS (KFC-W3000LS user only)
Notes:
• The illumination function of the KFC-W3000LS is enabled only
when it is connected to the KFC-W3000L through the Link cable
4.
The illumination function cannot be used when the KFC-
W3000LS is not connected to the KFC-W3000L.
• The maximum number of connected KFC-W3000LS units is 3
(the maximum total number of Woofer units including the KFC-
W3000L is 4).
• The illumination function cannot be used if the Link cable 4 is
connected erroneously to the LINK OUT jack of the Woofer unit
2 (KFC-W3000LS). Be sure to connect the Link cable 4 to the
LINK IN jack.
• The illumination is synchronized with the music signal input at
the speaker terminal of the Woofer unit 1 (KFC-W3000L).
The illuminations of the connected Woofer units 2, 3, 4 (KFC-
W3000LS) light according to the Woofer unit 1 (KFC-W3000L).
Note that they are not synchronized with the signals input to
them.
• Do not plug or unplug the connection cables without switching
the power off. Otherwise, malfunction may result.
Woofer unit 1
(KFC-W3000L)
Woofer unit 2
(KFC-W3000LS)
Amplifier Amplifier
1 Control box
Woofer unit 3
Woofer unit 4
4 Link cable
1 Connect the LINK OUT jack of the Woofer unit 1
(KFC-W3000L) and LINK IN jack of the Woofer unit
2 (KFC-W3000LS) using Link cable 4.
2 Connect the amplifier and the Woofer unit with
speaker cords.
Fuse exchange
Exchange with the specified capacity fuse.
Removal Insertion
Fuse
Cover
Fuse holder
Replacement fuse 2A
1 Open the cover.
2 Grasp with pliers and pull up. 1 Insert the fuse gently into the fuse holder and
push in all the way with your finger or tool.
2 Close the cover.
Caution: Be sure to replace with same capacity (amperage) as displayed on the fuse. This product is 2A.
B61-1329_EN.indd 5 08.3.13 5:13:46 PM