Kenwood KDC-BT33U - Manual (Page 6)

4
GETTING STARTED
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: “CANCEL DEMO”
\ “PRESS” \ “VOLUME KNOB”
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
Set the clock
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select [SETTINGS], then press the knob.
3 Turn the volume knob to select [CLOCK], then press the knob.
4 Turn the volume knob to select [CLOCK ADJUST]/ [CLOCK ADJ], then
press the knob.
5 Turn the volume knob to adjust the hour, then press the knob.
6 Turn the volume knob to adjust the minute, then press the knob.
Press 4 / ¢ to move between the hour and minute adjustment.
7 Press and hold to exit.
(or)
Press and hold SCRL DISP to enter clock adjustment mode directly
while in clock display screen.
Then, perform steps 5 and 6 above to set the clock.
1
2
Set the initial settings
1 Press SRC to enter [STANDBY].
2 Press the volume knob to enter [FUNCTION].
3 Turn the volume knob to select [INITIAL SET], then press the knob.
4 Turn the volume knob to make a selection (see the following table), then
press the knob.
5 Press and hold to exit.
• To return to the previous hierarchy, press .
Default: XX
PRESET TYPE NORMAL/ NORM: Memorizes one station for each preset button in each band
(FM1/ FM2/ FM3/ MW/ LW). ; MIX: Memorizes one station for each preset button
regardless of the selected band.
KEY BEEP ON: Activates the keypress tone. ; OFF: Deactivates.
RUSSIAN SET ON: Folder name, file name, song title, artist name, album name are displayed in
Russian (if applicable). ; OFF: Cancels.
P-OFF WAIT Applicable only when the demonstration mode is turned off.
Sets the duration when the unit will automatically turns off (while in standby mode)
to save the battery.
––– : Cancels ; 20M: 20 minutes ; 40M: 40 minutes ; 60M: 60 minutes
BUILT-IN AUX/
BUILTIN AUX
ON: Enables AUX in source selection. ; OFF: Disables. (➜ 7)
CD READ 1: Automatically distinguishes between audio file disc and music CD. ; 2: Forces to
play as a music CD. No sound can be heard if an audio file disc is played.
SWITCH PREOUT/
SWITCH PRE REAR/ SUB-W: Selects whether rear speakers or a subwoofer are connected to the
line out terminals on the rear (through an external amplifier).
SP SELECT OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches or
4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance.
F/W UPDATE
F/W UP xx.xx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
3
EN_KDC-BT43U_001A_4.indd 4 EN_KDC-BT43U_001A_4.indd 4 10/19/12 9:05:56 AM 10/19/12 9:05:56 AM