Kenwood KDC-BT33U - Manual (Page 16)

14
Symptom Remedy
Bluetooth®
No Bluetooth device is
detected. • Search from the Bluetooth device again.
• Reset the unit. (➜ 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to both the unit
and Bluetooth device.
• Delete pairing information from both the unit and the Bluetooth
device, then perform pairing again.
“DEVICE FULL” appears. The number of registered devices has reached its limit. Retry
after deleting an unnecessary device.
Echo or noise occurs. • KDC-BT43U : Adjust the microphone unit’s position. (➜ 8)
• Check the [ECHO LEVEL] setting. (➜ 10)
Phone sound quality is
poor. • Reduce the distance between the unit and the Bluetooth device.
• Move the car to a place where you can get a better signal reception.
Voice calling method is
not successful. • Use voice calling method in a more quiet environment.
• Reduce the distance from the microphone when you speak the
name.
• Make sure the same voice as the registered voice tag is used.
“NOT SUPPORT” appears. The connected phone does not support Voice Recognition feature.
“ERROR” appears. Try the operation again. If “ERROR” appears again, check if the
device supports the function you have tried.
Sound is being
interrupted or skipped
during playback of a
Bluetooth audio player. • Reduce the distance between the unit and the Bluetooth audio
player.
• Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to the unit.
The connected Bluetooth
audio player cannot be
controlled. • Check whether the connected Bluetooth audio player supports
Audio/Video Remote Control Profile (AVRCP). (Refer to the
instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
“HF ERROR” appears. Reset the unit and try the operation again. If this does not solve
the problem, consult your nearest service center.
TROUBLESHOOTING
Symptom Remedy
“NO DEVICE” appears. Connect a USB device, and change the source to USB again.
“COPY PRO” appears. A copy-protected file is played.
“NO MUSIC” appears. Connect a USB device that contains playable audio files.
“NA DEVICE” appears. Connect a supported USB device, and check the
connections.
“USB ERROR” appears. • Remove the USB device, turn the unit off, then turn it on
again.
• Try to connect another USB device.
“iPod ERROR” appears. • Reconnect the iPod.
• Reset the iPod.
Noise is generated. Skip to another track or change the disc.
Tracks do not play back as you
have intended them to play.
Playback order is determined when files are recorded.
“READING” keeps flashing. Do not use too many hierarchical levels or folders.
Elapsed playing time is not
correct.
This is caused by how the tracks are recorded.
The number of songs contained in
the “SONGS” category of this unit
is different from the iPod/iPhone.
Podcast files are not counted on this unit as this unit does
not support the playback of podcast files.
Correct characters are not
displayed (e.g. album name).
This unit can only display uppercase letters, numbers, and
a limited number of symbols. Uppercase Cyrillic letters can
also be displayed if [RUSSIAN SET] is set to [ON]. (➜ 4)
EN_KDC-BT43U_001A_4.indd 14 EN_KDC-BT43U_001A_4.indd 14 10/19/12 9:06:00 AM 10/19/12 9:06:00 AM