Kenwood TK-2360E - Manual (Page 21)

3
3 press the PTT switch and speak into the microphone.
release the PTT switch to receive.
• For best sound quality, hold the transceiver approximately
.5 inches (3 ~ 4 cm) from your mouth .
• If signaling has been programmed on the channel, you will
hear a call only if the received signal matches your transceiver
settings .
SCAN
scan monitors for signals on the transceiver channels . While
scanning, the transceiver checks for a signal on each channel
and only stops if a signal is present .
to begin scanning, press the key programmed as Scan .
• When a signal is detected on a channel, scan pauses at that
channel. The transceiver will remain on the busy channel until the
signal is no longer present, at which time Scan resumes.
to stop scanning, press the Scan key again .
Note: to use scan, there must be at least 2 channels in the scan
sequence .
PrIOrITy SCAN
if a priority channel has been programmed, the transceiver
will automatically change to the Priority channel when a call is
received on that channel, even if a call is being received on a
normal channel .
if the priority channel has been set as operator selectable by
your dealer, you can set a new channel as the Priority channel
by selecting your desired channel and pressing the key
programmed as Priority Channel Select .