Kenwood TK-7360E - Manual (Page 18)

3
4 Press S to enter Status mode.
5 Press / (if the key assignment list selection is configured as “Enabled”)
or /C> to select the status ID you want to transmit.
• You can also enter the status ID directly by using the keypad.
6 Press the PTT switch or n to initiate the status call.
n
Receiving
When a status call is received, the icon will flash and the calling ID or
text message will appear on the display. Press any key to return to normal
operation.
n Reviewing Messages in the Stack
1 Press and hold the key programmed as Stack, Selcall, Status, or
Selcall + Status .
2 Press / (if the key assignment list selection is configured as “Enabled”)
or /C> to select your desired message.
3 Press to return to normal operation.
S
hort
/l
ong
m
eSSAgeS
To send and receive short or long messages, use the Selcall + Short Message
or Short Message functions, or connect the transceiver to a PC. (Ask your
dealer for details.)
• Short messages can contain a maximum of 4 characters. Received short messages
are displayed the same as Status messages and are stored in the same stack memory.
A combined maximum of 5 Status calls and short messages can be stored in the stack
memory.
• Long messages can contain a maximum of 406 characters and can only be viewed via
a PC.
gpS r
eport
If a GPS unit (NMEA-03 format) is installed on your transceiver, you can press
the key programmed as Send the GPS data to send your location data.
ADVANCED OPERATIONS
e
mergency
c
AllS
If your transceiver has been programmed with the Emergency function, you can
make emergency calls.
1
Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your transceiver, the length of time
you must hold the Emergency key will vary.