Kenwood TK-7360E - Manual (Page 11)

6
BASIC OPERATIONS
S
witching
p
ower
on/ oFF
Press to switch the transceiver ON.
• A beep sounds and the display illuminates. If the Power-on tone select is set to OFF,
the beep will not sound.
• If the Transceiver Password function is programmed, “PASSWORD” will appear on the
display. Refer to “Transceiver Password”, on page 6.
Press again to switch the transceiver OFF.
n
Transceiver Password
To enter the password:
1 Press / to select a digit.
• When using a keypad, simply enter the password digits and proceed to step 4.
2 Press C> to accept the entered digit and move to the next digit.
• Press A or # to delete an incorrect digit. Press and hold A or # to delete all
digits.
3 Repeat steps and 2 to enter the entire password.
4 Press S or to confirm the password.
• If you enter an incorrect password, the transceiver remains locked.
A
djuSting the
V
olume
Press the Volume Up key to increase the volume. Press the Volume Down key
to decrease the volume.
If Squelch Off has been programmed onto a key, you can use that function to
listen to background noise while adjusting the volume level.
S
electing A
Z
one And
c
hAnnel
/g
roup
id
Select the desired zone and channel/group ID using the keys programmed as
Zone Up / Zone Down and CH/GID Up/ CH/GID Down.
• You can program names for zones and channels/group IDs with up to 0
characters.
n Home Channel/Group ID
You can select your Home channel/group ID by pressing Home CH/GID.
Press the key a second time to return to your previous channel/group ID.
n Direct Channel/Group ID
You can quickly select a commonly used channel/group ID by pressing Direct
CH/GID 1 ~ Direct CH/GID 4. Press the same key a second time to return to
your previous channel/group ID (if the key assignment Direct CH/GID return is
configured as “Enabled”).