beautypg.com

Scan – Kenwood TK-7360E User Manual

Page 12

background image

t

rAnSmitting

/ r

eceiVing

1

Select your desired zone and channel.

2

Press the microphone PTT switch and speak into the microphone to transmit.

Release the PTT switch to receive.

• For best sound quality at the receiving station, hold the microphone approximately

.5 inches (3 ~ 4 cm) from your mouth.

SCAN

Scan monitors for signals on the transceiver channels. While scanning, the

transceiver checks for a signal on each channel and only stops if a matching

signal is present. There are two types of scans available.

Single Scan: Monitors the channels of only the currently selected zone. If set up to

scan the Priority channel, it will be scanned even if it is not in the selected zone.

Multi Scan: Monitors the channels of every zone.

To start/stop scanning, press the key programmed as Scan.

• “SCAN” and the icon appear on the display during scan.

• When a signal is detected, scan pauses at that channel. The transceiver will remain on

the busy channel until the signal is no longer present, at which time scan resumes.

Note:

To use Scan, there must be at least 2 channels added to the scan sequence.

c

hAnnel

r

ecAll

During scan, you can recall the last zone and channel/group ID on which you

made a call by pressing the key programmed as CH/GID Recall. Scan will

remain paused on the Recall channel until you press the key again.

p

riority

S

cAn

If a Priority channel has been programmed, the transceiver will automatically

change to the Priority channel when a call is received on that channel, even if a

call is being received on a normal channel.

• The icon appears on the display when the Priority channel is selected.

t

emporAry

c

hAnnel

l

ockout

During scan, you can temporarily remove specific channels from the scanning

sequence by pressing the key programmed as Scan Delete/Add while Scan is

paused at the undesired channel. To temporarily remove a zone, press and hold

Scan Delete/Add

while Scan is paused at a channel in the undesired zone.

• The channel/zone is no longer scanned. However, when scanning is ended and

restarted, the Scan settings return to normal.

This manual is related to the following products: