Signaling, Tone signaling, Qt)/ d – Kenwood TK-7360E User Manual
Page 15: Dqt), Ost)
0
SIGNALING
Q
uiet
t
Alk
(Qt)/ d
igitAl
Q
uiet
t
Alk
(dQt)
Your dealer may have programmed QT or DQT signaling on your transceiver
channels. A QT tone/ DQT code is a sub-audible tone/code which allows you to
ignore (not hear) calls from other parties who are using the same channel.
o
ptionAl
S
ignAling
Your dealer may also program several types of optional signaling for your
transceiver channels.
5-Tone Signaling:
Refer to “5-TONE SIGNALING” on page 0.
DTMF Signaling:
DTMF Signaling opens the squelch only when the transceiver
receives a call containing a matching DTMF code.
FleetSync Signaling:
Refer to “S
elcall
(S
elective
c
alling
)” on page .
MDC-1200:
MDC-200 is a data system using Audio Frequency Shift Keying
(AFSK). Transceivers communicate at a 200 baud rate, using 200 Hz and
00 Hz tones.
o
perAtor
S
electAble
t
one
(oSt)
You can change the preset encode and decode tones for the selected channel.
Up to 40 OST pairs can be pre-programmed by your dealer.
1
Select your desired channel.
2
Press and hold the key programmed as OST.
• “TONE” appears on the display, followed by the current OST number.
3
Press / (if the key assignment list selection is configured as “Enabled”) or
/C> to select your desired OST number.
• You can also directly enter a number from 0 to 40 using the keypad.
4
Use the transceiver the same as in a regular call.
5
To exit OST mode and return to the preset encode/decode tones, press .
5-TONE SIGNALING
5-tone Signaling opens the squelch only when the transceiver receives a matching
call. Transceivers that do not transmit the correct tones will not be heard.
Note:
Your transceiver functions can include either 5-tone Signaling or FleetSync/ MDC-200.
m
Aking
A
S
elcAll
(S
electiVe
c
Alling
)
A Selcall is a voice call to a particular station or to a group of stations.
1
Select your desired zone and channel.