Kenwood C-707i-W - Manual (Page 4)

C-707I 4
8. Power Cord Protection
– Power-supply cords should be routed so that
they are not likely to be walked on or pinched
by items placed upon or against them, paying
particular attention to cords at plugs, convenience
receptacles, and the point where they exit from
the product.
9. Lightning
– For added protection for this product during
a lightning storm, or when it is left unattended
and unused for long periods of time, unplug it
from the wall outlet and disconnect the antenna
or cable system. This will prevent damage to the
product due to lightning and power-line surges.
10. Overloading
– Do not overload wall outlets, extension cords, or
integral convenience receptacles as this can result
in a risk of fi re or electric shock.
11. Object and Liquid Entry
– Never push objects of any kind into this product
through openings as they may touch dangerous
voltage points or short-out parts that could result
in a fi re or electric shock. Never spill liquid of any
kind on the product.
12. Servicing
– Do not attempt to service this product yourself
as opening or removing covers may expose you
to dangerous voltage or other hazards. Refer all
servicing to qualifi ed service personnel.
13. Damage Requiring Service
– Unplug this product from the wall outlet and
refer servicing to qualifi ed service personnel
under the following conditions:
a) When the power-supply cord or plug is
damaged,
b) If liquid has been spilled, or objects have
fallen into the product,
c) If the product has been exposed to rain or
water,
d) If the product does not operate normally
by following the operating instructions.
e) If the product has been dropped or
damaged in any way, and
f) When the product exhibits a distinct
change in performance – this indicates a
need for service.
g) If an abnormal smell or smoke is detected.
14. Replacement Parts
– When replacement parts are required, be sure
the service technician has used replacement parts
specifi ed by the manufacturer or have the same
characteristics as the original part. Unauthorized
substitutions may result in fi re, electric shock, or
other hazards.
15. Safety Check
– Upon completion of any service or repairs to
this product, ask the service technician to perform
safety checks to determine that the product is in
proper operating condition.
16. Wall or Ceiling Mounting
– This product should be mounted to a wall
or ceiling only as recommended by the
manufacturer.
17. Heat
– This product should be situated away from heat
sources such as radiators, heat registers, stoves, or
other products that produce heat. Do not place a
fl aming object, such as a candle or lantern, or near
the product.
18. Power Lines
– An outside antenna system should not be
located in the vicinity of overhead power lines
or other electric light or power circuits, or where
it can fall into such power lines or circuits. When
installing an outside antenna system, extreme
care should be taken to keep from touching such
power lines or circuits as contact with them might
be fatal.
IMPORTANT SAFETY INSTRUCTIONS
Safety Precautions
en01_c-707i.indd 4 en01_c-707i.indd 4 12/27/2007 4:29:07 PM 12/27/2007 4:29:07 PM