Kenwood C-707i-W - Manual (Page 16)

C-707I 16
Connecting Other (Commercially Available) Devices
Connecting the System
When connecting a related system component, read the instruction manual that comes with the component
too.
Ensure that all the cords are securely connected. Loose or incomplete connections may result in noise
interference or no sound at all.
Caution for outdoor
antenna installation
Since antenna installation requires skill and experience, always consult
your dealer before installation. The antenna should be located away from
power lines. If the antenna falls over, contact with a power line creates
the risk of electric shock.
D.AUDIO IN
Connect digital audio players to the [D.AUDIO IN] terminal
on the front panel of the main unit.
If you connect a Kenwood player that supports digital
audio link using the dedicated cable, you can control the
player from the main unit and the remote control. (Page
48) It can also be connected using a 3.5 mm stereo mini-
plug cable (commercially available unit).
When you are not using the digital audio player, unplug
the mini-plug cable from the main unit.
Digital audio player
USB
Connect USB fl ash memory or USB mass storage class
compliant digital audio players to the [
USB] port on
the front panel of the main unit.
Depending on the device being connected, it may take
some time for the system to recognize it.
With some models, a USB connection mode selection
screen will appear. Select “Storage Mode”.
To connect other devices to the front panel connectors of the main unit,
raise the panel cover and then connect the devices.
Raise
Panel cover
Opening the front panel
en02_c-707i.indd 16 en02_c-707i.indd 16 12/27/2007 3:14:38 PM 12/27/2007 3:14:38 PM