Siemens KI86NAD30 - Manual (Page 41)

en
41
Fault Possible cause Remedial action
Warning signal
sounds, “alarm”
button lights up.
Fig. 2/5
The freezer
compartment is too
warm!
Frozen food is at risk! To switch off the warning signal,
press the “alarm” button 5.
Appliance is open. Close the appliance.
Ventilation openings
have been covered. Ensure that there is adequate
ventilation.
Too much food was
placed in the freezer
compartment at once. Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the “alarm” button 5 goes out
shortly afterwards.
Freezer compartment
temperature display
flashes. Fig. 2/4
Warning signal
sounds.
The alarm button is lit.
Fig. 2/5
The freezer
compartment is too
warm!
Frozen food is at risk! To switch off the warning signal,
press the “alarm” button, Fig. 2/5.
Appliance is open. Close the appliance.
Ventilation openings
have been covered. Ensure that there is adequate
ventilation.
Too much food was
placed in the freezer
compartment at once. Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the alarm display goes out shortly
afterwards.
Freezer compartment
temperature display
flashes. Fig. 2/4 A fault caused
the freezer
compartment
to become too warm
in the past. When the alarm button 5 is pressed,
the temperature display stops
flashing. Fig. 2/4
The temperature display indicates
for 5 seconds the warmest
temperature which was reached
in the freezer compartment.
Appliance is not
cooling, temperature
display and light
are lit. Showroom mode is
switched on. Hold down alarm button, Fig 2/5,
for 10 seconds until an
acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.