Catalytic cooking compartment panels, Removing and fitting the appliance door, Removing the appliance door – Siemens HV541ANS0 User Manual
Page 23: Risk of injury, Open the oven door fully, Note, Raise the oven door slightly and pull it out, Fitting the appliance door, Grip the oven door on either side with both hands, Slide the hinges into the slots in the oven (a)
23
Catalytic cooking compartment panels
The catalytic cooking compartment panels are coated with self-
cleaning enamel.
The surfaces clean themselves while the oven is in operation.
Larger splashes will only be removed after the oven has been
used several times.
Self-cleaning surfaces
The side walls are covered with catalytic panelling. Never clean
these surfaces with oven cleaner. Slight discolouration of the
enamel does not affect automatic self-cleaning.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
Removing the appliance door
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. When removing the oven door, ensure that the locking
pins are fully inserted into the holes in the hinges.
1.
Open the oven door fully.
2.
Lock both hinges on the left and right using a locking pin (a).
Note: The locking pins must be fully inserted into the holes in
the hinges.
3.
Grip the oven door on either side with both hands and close
the oven door by approx. 30° (b).
4.
Raise the oven door slightly and pull it out.
Note: Do not fully close the oven door. The hinges may
become bent and the enamel may be damaged.
Fitting the appliance door
1.
Grip the oven door on either side with both hands.
2.
Slide the hinges into the slots in the oven (a).
Note: The notch below the hinges must engage into the
frame of the oven (b).
3.
Lower the door downwards.
4.
Remove the locking pins.
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call after-sales service.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removing the door panels
1.
Remove the oven door and lay it on a cloth with the handle
facing down.
2.
Lift the bottom of the inner panel slightly until the fastening
pins come out of the holder (1).
3.
Carefully lift the top of the inner panel until the fastening pins
come out of the holder (2).
Caution!
When lifting the inner panel, the middle panel may stick to the
inner panel. Make sure that the middle panel does not fall.
4.
Remove the inner panel.
Shelves
Hot soapy water:
Soak and clean with a dish cloth or
brush.
Accessories
Hot soapy water:
Soak and clean with a dish cloth or
brush.
Area
Cleaning agents
D
E
D
E