Siemens GS33NVW30 - Manual (Page 24)

en
24
Defrosting
Refrigerator compartment
defrosts fully automatically
While the refrigerating unit is running,
beads of condensation or hoarfrost form
at the back of the refrigerator
compartment. This is quite normal. It is
not necessary to wipe off the
condensation or frost. The rear panel
defrosts automatically. The condensation
runs into the condensation channel,
Fig. +. and is conveyed to the
refrigerating unit where it evaporates.
Note
Keep the condensation channel and
drainage hole clean, so that the
condensation can run out.
Cleaning the appliance
ã=
Caution
■ Do not use abrasive, chloride or acidic
cleaning agents or solvents.
■ Do not use scouring or abrasive
sponges. The metallic surfaces could
corrode.
■ Never clean shelves and containers in
the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch the appliance
off.
2. Pull out the mains plug or switch off
the fuse.
3. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
4. Wipe the door seal with clear water
only and then wipe dry thoroughly.
5. Rinsing water must not run through
the drainage hole into the evaporation
area.
6. After cleaning reconnect and switch
the appliance back on.
Interior fittings
All variable parts of the appliance can be
taken out for cleaning.
Take out glass shelves
Fig. 4
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Condensation channel
Fig. +
Regularly clean the condensation
channel and drainage hole with a cotton
bud or similar implement to ensure that
the condensation can drain.
Take out shelves in the door
Fig. 5
Lift shelves upwards and take out.