Asus A7V266-MX - Manual (Page 26)

1-18 Chapter 1: Product introduction
4. ATX power connectors (20-pin ATXPWR)
These connectors connect to an ATX 12V power supply. The plugs from the
power supply are designed to fit these connectors in only one orientation. Find
the proper orientation and push down firmly until the connectors completely fit.
If you will need to replace the power supply in the future, make sure that your
new ATX 12V power supply can provide 8A on the +12V lead and at least 1A on
the +5-volt standby lead (+5VSB). The minimum recommended wattage is
230W, or 300W for a fully configured system. The system may become unstable
and may experience difficulty powering up if the power supply is inadequate.
A7V266-MX
®
A7V266-MX ATX Power Connector
ATXPWR
+3.3VDC
-12.0VDC
COM
PS_ON#
COM
COM
COM
-5.0VDC
+5.0VDC
+5.0VDC
PWR_OK
+12.0VDC
+3.3VDC
+3.3VDC
COM
+5.0VDC
COM
+5.0VDC
COM
+5VSB
3. Digital Audio Connector (6-1 pin SPDIF)
This connector is for optional S/PDIF audio module that allows digital instead
of analog sound input and output.
When you input sound for S/PDIF IN, the LINE_OUT will output the sound.
Mute LINE_OUT to impede sound output from S/PDIF IN. The S/PDIF module
is not included in this motherboard package.
A7V266-MX
®
A7V266-MX Digital Audio Connector
+5V SPDIFOUT GND
SPDIF