Siemens TE502206RW - Manual (Page 17)

13
en
3. Remove the frothing tube (6c).
6c
4. Clean the individual parts with a detergent
solution and a soft brush. If necessary,
soak in a warm detergent solution.
Clean the air hole (6e) thoroughly.
6e
5. Rinse all parts with clean water and dry.
6. Fit the steam nozzle (6d) and frothing
tube (6c) back into the metal sleeve.
1 2
6d 6c
7. Twist the steam nozzle clockwise until
the marks are aligned.
8. Attach the milk frother to the steam
valve. Check that the red mark on the
steam valve is covered.
A Risk of scalding
Only use the appliance when the milk
frother (6) is completely assembled and
fitted.
Cleaning the brewing unit
Clean the brewing unit regularly.
To pre-clean the brewing unit automatically:
1. Select
e
by turning the rotary knob (14).
2. Place an empty glass under outlet (7).
3. Press the start button (10).
The appliance rinses.
In addition to the automatic cleaning
programme, the brewing unit (5a) should be
removed regularly for cleaning. (See figure
E at the start of the operating instructions.)
1. Switch the appliance off at the power
on/off switch O / I (9). No buttons are lit.
2. Open the door (5b) to the brewing unit.
3. Slide the red lock (5d) on the brewing
unit (5a) completely to the left.
4. Press the eject lever (5c) down fully.
The brewing unit is released.
5. Grasp the brewing unit (5a) by the
recessed grips and remove carefully.
6. Remove the cover (5e) of the brewing
unit and rinse the brewing unit (5a)
thoroughly under running water.