Siemens TE503209RW User Manual
Page 25
21
en
Problem
Cause
Solution
The water filter does not
stay in position in the
water tank (16)�
The water filter is not
mounted correctly�
Firmly press the water filter
straight down into the tank
connection�
Display shows
Check water tank
Water tank has been
incorrectly inserted or the
new water filter has not
been rinsed according to
instructions�
Insert the water tank correctly or
rinse the water filter according to
instructions and then switch on�
Carbonated water in the
water tank�
Fill the water tank with fresh tap
water�
The coffee grounds are
not compact and are too
wet�
The grinding setting is too
fine or too coarse, or not
enough ground coffee has
been used�
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee�
Display shows
Clean brewing unit
Brewing unit (5) is soiled�
Clean brewing unit (5)�
Too much pre-ground
coffee in the brewing unit
(5)�
Clean brewing unit (5)� Pour in
no more than 2 level measuring
spoons of ground coffee�
The brewing unit’s
mechanism is stiff�
Remove and clean the brewing
unit, see “Maintenance and
daily cleaning”�
Coffee or milk froth quality
varies considerably�
Build-up of limescale in the
appliance�
Descale the appliance as
described in the instructions�
Water dripped onto the
inner floor of the appliance
when the drip tray (8) was
removed�
Drip tray (8) removed too
early�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray (8)�
Display shows
Insert brewing unit
Brewing unit (5) is missing
or was not recognised�
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance�
Restore the unit to its
original factory settings
(“Reset”)�
You changed some settings
and want to discard them�
Turn off the unit with the power
on/off switch
O / I (9)� Press and
hold the
e
off /
j
(12) and the
h
(11) button and turn the appliance
on with the power on/off switch
O / I (9). Confirm by pressing
the start button
start (10)�
The factory settings are now
activated�
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.