Siemens TE503209RW - Manual (Page 19)

15
en
Tips on energy saving
● Switch off the fully automatic espresso
machine when not in use� To do this,
press the
e
off / j (12) button� The
appliance rinses and switches off�
● If possible, do not interrupt coffee or
milk froth dispensing� Cutting the coffee
or milk froth dispensing process short
results in higher energy consumption
and in more residual water collecting in
the drip tray�
● Descale the appliance regularly to
avoid a build-up of limescale� Lime-
scale residue results in higher energy
consumption�
Service Programmes
Tip: Refer also to the quick reference guide
in the storage compartment (5c)�
Depending on usage, the following
messages will appear on the display at
certain intervals:
Descale required!
or
Clean required!
or
Calc‘n‘Clean required!
The appliance should be cleaned or
descaled immediately using the corre-
sponding programme� You also have the
option of combining both processes with the
Calc‘n‘Clean function (see “Calc‘n‘Clean“)�
If the service programme is not run as
instructed, the appliance may be damaged�
A Warning!
Each time you run the service programme,
you should follow the instructions for using
the descaling and cleaning agents� Please
observe the safety instructions on the pack-
aging of the cleaning agent�
Never interrupt the service programme!
Do not drink the liquids!
Never use vinegar, vinegar-based products,
citric acid or citric acid-based products!
Never put descaling tablets or other desca-
ling agents in the ground coffee drawer or
the drawer for cleaning tablets (4)!
Specially developed descaling and
cleaning tablets are available from
retailers or customer service (see
“Accessories”).
Important: If there is a filter in the water
tank (16), it needs to be removed before the
service programme is run�
Descaling
Duration: approx� 25 minutes
Important: If there is a filter in the water
tank (16), it needs to be removed before the
descaling programme is run�
If the message Descale required! appears
on the display, press the
e
off / j button
(12) for 3 seconds and then press the start
button (10)� The descaling programme will
start�
To descale the appliance before being
prompted, press the
e
off / j button (12) for
at least 3 seconds� Then press the
e
off / j
button (12) briefly twice. Turn the upper
rotary knob (14) until Start descaling
appears in the display�
To start the descaling procedure, press the
start button (10)�
The display will guide you through the
programme�