Siemens TE809201RW User Manual
Page 27
23
en
● Press the
start button 8. The appliance
rinses twice.
Cleaning
Open powder compartment
● Open the powder compartment
18.
Insert Siemens cleaning tablet and
close powder compartment
● Drop a Siemens cleaning tablet in the
drawer
18 and close.
Remove water filter ▶ start
Info: If the water filter 29 is activated, the
display will prompt you to remove the filter
29, then press the start button 8 again.
Add 0.5 l water and descaler ▶ start
● Pour lukewarm water into the empty
water tank
11 up to the “0.5 l” mark and
then dissolve two Siemens descaling
tablets in it.
● Press the
start button 8. The descaling
programme now runs for about
20 minutes.
Descaling
Not enough descaling fluid.
Refill fluid ▶ start
Info: If there is not enough descaling solu-
tion in the water tank
11, the corresponding
prompt is displayed. Pour in descaling solu-
tion and press the
start button 8 again.
Clean and refill water tank ▶ start
● Rinse the water tank
11 and refill it with
fresh water up to the “
max” mark.
● Press the
start button 8. The descaling
programme now runs for about 1 minute
more, followed by the cleaning pro-
gramme for about 7 minutes, and rinses
the appliance.
Descaling
Cleaning
Empty drip tray
Replace drip tray
● Empty the drip tray
23 and reinsert it.
Replace the filter if one is being used. The
appliance has completed descaling and
cleaning and is ready for use again.
Important: Wipe down the appliance
using a soft, damp cloth to immediately
remove any descaler residue. Such residue
can cause corrosion. New sponge cloths
may contain salts. Salts can cause rust
film on stainless steel and must therefore
be washed out thoroughly before use.
Thoroughly clean the suction pipe
10d of
the milk frother.
Note: If one of the service programmes
is interrupted, e. g. by a power outage,
proceed as follows:
● Rinse the water tank
11 and refill it with
fresh water up to the “
max” mark.
● Press the
start button 8. The cleaning
programme now runs for about 3 minutes,
and rinses the appliance.
Cleaning
Empty drip tray
Replace drip tray
● Empty the drip tray
23 and reinsert it.
The appliance is ready for use again.
TE809_1RW.indb 23
08.05.2013 14:32:39