Kenwood DDX771 - Manual (Page 57)

ENGLISH 57
CONNECTION/INSTALLATION
Connecting microphone for Bluetooth
(only for DDX771/DDX491HD/
DDX471HD/DDX371/DDX310BT/
DDX3071BT)
Connect the microphone (7) to the MIC terminal.
• To install the microphone, peel off the adhesive
tape, fix on the installation position, then adjust
the direction of the microphone to face the driver.
After installing, fix the microphone cable to the car
with clamps (commercially available).
7
Removing the unit
Removing the trim plate
1 Engage the catch pins on the extraction
key (4) and remove the two locks on the
lower part. Lower the frame and pull it
forward.
4
2 Remove the upper two locations.
• The frame can be removed from the top side in
the same manner.
Removing the unit
1 Remove the trim plate. (See the left
column.)
2 Insert the two extraction keys (4), then
pull them as illustrated so tat the unit can
be removed.
4
• Be careful to avoid injury from the catch pins on
the extraction key.
DDX_Entry_K.indb 57 2013/11/01 16:10