Kenwood NX-210G User Manual

Page 32

•

Select “ALL” Fleet and “ALL” ID to make a call to all units
(Broadcast call).

•

Select “ALL” Fleet and enter an ID number to make a call to
the selected ID in all fleets (Supervisor call).

Note:
◆

Broadcast and Supervisor calls are programmed functions that

cannot be made with a keypad.

◆

The ID range may be limited by programming.

TATUS

ESSAGE

You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to 16
alphanumeric characters. Status messages range from 10 to
99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages (combined status
messages and short messages) can be stored in the stack
memory of your transceiver.

■ Transmitting

1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status

mode (proceed to step 5) or Selcall + Status to enter
Selcall mode (proceed to step 3).

3 Press /

to select the station you want to call.

•

If Manual Dialing is enabled, you can enter a station ID by
using the DTMF keypad, or by using

. When using

, cycle through the digits to select a digit, then

press

to set the digit and move the cursor to the right.

Repeat this process until the entire ID is entered.

4 Press to enter Status mode.
5 Press /

to select the status you want to transmit.

•

If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using

(refer to step

3, above).