Kenwood TH-D72A - Manual (Page 25)

16
6(/(&7,1*'8$/%$1'02'(6,1*/(%$1'02'(
You can switch the transceiver between dual band operation and single band
operation.
1 Select your desired band (A or B).
2 Press [DUAL].
• Each time you press [DUAL] , the transceiver switches between Single band
mode and Dual band mode.
Dual band mode:
Single band mode (band A only): Single band mode (band B only):
6(/(&7,1*$)5(48(1&<%$1'
You can change the frequency bands for bands A and B.
1 Select your desired band (A or B).
2 Press [F], [A/B].
• Each time you press [F], [A/B] , you cycle to the next frequency band.
• Band A: 144 ° 430/440 ° 144 (MHz).
• Band B: 118 ° 144 ° 300 ° 430/440 ° 118 (MHz).
Note: The TH-D72E uses the 430 MHz band and the TH-D72A uses the 440 MHz band.
• When masking a band, you are restricted to using only the selectable band.
• When receiving 2 signals on the same band, the image interference, sensitivity,
etc., performance will decrease.